Trending: Anna University 8th Sem Results April 2014 May/June 2014 Time Table/ Internal Marks Calculate CGPA Online SSLC Results 2014 12th Result 2014

Test Footer 1

Friday, February 1, 2013

CI 9258 DESIGN FOR MANUFACTURING SYLLABUS | ANNA UNIVERSITY ME COMPUTER INTEGRATED MANUFACTURING ELECTIVES SYLLABUS REGULATION 2009 2011 2012-2013

Latest: TNEA 2014 Engineering Application Status, Counselling Date, Rank List
CI 9258 DESIGN FOR MANUFACTURING SYLLABUS | ANNA UNIVERSITY ME COMPUTER INTEGRATED MANUFACTURING ELECTIVES SYLLABUS REGULATION 2009 2011 2012-2013 BELOW IS THE ANNA UNIVERSITY M.E COMPUTER INTEGRATED MANUFACTURING DEPARTMENT ELECTIVES SYLLABUS, TEXTBOOKS, REFERENCE BOOKS,EXAM PORTIONS,QUESTION BANK,PREVIOUS YEAR QUESTION PAPERS,MODEL QUESTION PAPERS, CLASS NOTES, IMPORTANT 2 MARKS, 8 MARKS, 16 MARKS TOPICS. IT IS APPLICABLE FOR ALL STUDENTS ADMITTED IN THE YEAR 2011 2012-2013 (ANNA UNIVERSITY CHENNAI,TRICHY,MADURAI,TIRUNELVELI,COIMBATORE), 2009 REGULATION OF ANNA UNIVERSITY CHENNAI AND STUDENTS ADMITTED IN ANNA UNIVERSITY CHENNAI DURING 2010

CI 9258 DESIGN FOR MANUFACTURING L T P C
3 0 0 3 AIM:
The aim is to impart the students with knowledge of the general design principles of
manufacturing and to provide complete informations for further study.
OBJECTIVES:
At the end of this course the student should be able to understand the design principles
of casting, welding, forming, machining and assembly, by considering various
manufacturing constraints.
UNIT I INTRODUCTION 6
Economics of Process selection – General design principles of manufacturability –
Proper material selection – Strength and Mechanical factors- Application of form design.
UNIT II CASTING DESIGN AND WELDMENT DESIGN 10
Factors affecting casting design- Strength aspects – Sand casting and die casting
design-Factors affecting weldment design-Gas and arc welding design.
UNIT III FORMED METAL COMPONENTS AND NON METALLIC
PARTDESIGN 10
Design considerations for the manufacture of extruded, cold headed metal parts – Tube
and section bends – Powder metal parts-Thermo setting plastic parts-Reinforced –
Plastic/Composite parts.
UNIT IV MACHINED COMPONENTS DESIGN 10
Design considerations for the manufacture of Turned parts-drilled parts-milled parts,
planned, shaped and slotted parts-Ground parts-parts produced by EDM.
UNIT V DESIGN FOR ASSEMBLY

Types of assembly – DFA –Index – evaluation of assembly – assembly cost reduction –
case of assembly – impact on quality – related software usage – case studies. TOTAL: 45 PERIODS TEXTBOOK:
1. James G. Bralla – “Handbook of product design for manufacture”, McGraw Hill
Book Co., 1986.
REFERENCES:
1. Henry Peck – “Designing for manufacture”, Sir Isaac Pitman & Sons Ltd., 1973.
2. Matousek – “Engineering Design”, Blackie & sons, 1956.

No comments:

Post a Comment

Any doubt ??? Just throw it Here...