Trending: Anna University 8th Sem Results April 2014 May/June 2014 Time Table/ Internal Marks Calculate CGPA Online SSLC Results 2014 12th Result 2014

Test Footer 1

Thursday, October 25, 2012

AR2251 DESIGN OF STRUCTURES I SYLLABUS | ANNA UNIVERSITY B ARCH 4TH SEM SYLLABUS REGULATION 2009 2011 2012-2013

Latest: TNEA 2014 Engineering Application Status, Counselling Date, Rank List
AR2251 DESIGN OF STRUCTURES I SYLLABUS | ANNA UNIVERSITY B ARCH 4TH SEM SYLLABUS REGULATION 2009 2011 2012-2013 BELOW IS THE ANNA UNIVERSITY FOURTH SEMESTER B.ARCH DEPARTMENT SYLLABUS, TEXTBOOKS, REFERENCE BOOKS,EXAM PORTIONS,QUESTION BANK,PREVIOUS YEAR QUESTION PAPERS,MODEL QUESTION PAPERS, CLASS NOTES, IMPORTANT 2 MARKS, 8 MARKS, 16 MARKS TOPICS. IT IS APPLICABLE FOR ALL STUDENTS ADMITTED IN THE YEAR 2011 2012-2013 (ANNA UNIVERSITY CHENNAI,TRICHY,MADURAI, TIRUNELVELI,COIMBATORE), 2009 REGULATION OF ANNA UNIVERSITY CHENNAI AND STUDENTS ADMITTED IN ANNA UNIVERSITY CHENNAI DURING 2009

AR2251 DESIGN OF STRUCTURES I L T P/S C
3 0 0 3
AIM:
To enable the design of timber and steel structural members in a building.
OBJECTIVES:
 To introduce the design of various timber components in a building.
 To enable the understanding of the types, efficiency and strength, advantages and
disadvantages of Rivet and welded joints in steel.
 To enable the design of Tension (beams) and compression (columns) steel members in a
building under various conditions.
CONTENT:
TIMBER STRUCTURES
UNIT I DESIGN OF BEAMS AND COLUMNS 7
Grading of Timber – Permissible Stresses – Design of timber beams – Madras terrace roof –
Design of timber columns.
STEEL STRUCTURES
UNIT II RIVETED AND WELDED JOINTS 12
Assumptions – failure of Riveted joints – Strength and Efficiency of Riveted Joints – Types –
Design of Riveted Joints for Axially Loaded Members (Excluding eccentric connections)
Types of welded joints – Advantages and disadvantages – Design of Fillet welds
(Excluding eccentric connections).
UNIT III TENSION MEMBERS 8
Introduction – Net sectional area – permissible stresses. Design of Axially loaded Tension
member – Lug angle – code provision – tension splice.
UNIT IV COMPRESSION MEMBERS 10
Introduction – various sections – built up section – Design of columns (excluding Lacing,
Battening and other connections.)
UNIT V STEEL BEAMS 8
Introduction – laterally supported and unsupported beams – Design of laterally supported
beams.
TOTAL: 45 PERIODS
REQUIRED READING
1. L.S. Negi, Design of Streel Structures – Tata McGraw Hill Publishing Company Ltd.,
23
New Delhi, 1997.
2. S. Ramachandra, Design of Steel Structures - Standard Book House, Delhi, 1984.
REFERENCES
1. A.S.Arya, Structural Design in Steel, Masonry and Timber, Nemchand and Bros, Roorkee,
1971.
2. National Building Code of India, 1983, Part VI, Structural Design.
3. Gurucharan Singh, Design of Steel Structures, Standard Publishers, New Delhi, 1982.
4. Dayaratnam.P, Design of Steel Structures, Oxford and IBH Publishing Co.
5. IS 883 – Code of Practice for Design of Structural Timber in Buildings
6. IS 800 – Code of Practice for use of Structural Steel in General Building Construction

No comments:

Post a Comment

Any doubt ??? Just throw it Here...