EC2208 ELECTRONIC CIRCUITS LAB I SYLLABUS | ANNA UNIVERSITY ECE THIRD SEMESTER SYLLABUS REGULATION 2008 2011-2012
BELOW IS THE ANNA UNIVERSITY 3RD SEMESTER BE ELECTRONICS AND COMMUNICATION DEPARTMENT SYLLABUS IT IS APPLICABLE FOR ALL STUDENTS ADMITTED IN THE YEAR 2011-2012(ANNA UNIVERSITY CHENNAI,TRICHY,MADURAI,TIRUNELVELI,COIMBATORE), 2008 REGULATION OF ANNA UNIVERSITY CHENNAI AND STUDENTS ADMITTED IN ANNA UNIVERSITY CHENNAI DURING 2009.
EC 2208 ELECTRONIC CIRCUITS LAB I L T P C
(Common to ECE & Bio Medical Engineering) 0 0 3 2
Expt No.1 Fixed Bias amplifier circuit using BJT
1. Waveforms at input and output without bias.
2. Determination of bias resistance to locate Q-point at center of load line.
3. Measurement of gain.
4. Plot the frequency response & Determination of Gain Bandwidth Product
Expt No.2 Design and construct BJT Common Emitter Amplifier using voltage
divider bias (self-bias) with and without bypassed emitter resistor.
1. Measurement of gain.
2. Plot the frequency response & Determination of Gain Bandwidth Product
Expt No.3 Design and construct BJT Common Collector Amplifier using voltage
divider bias (self-bias).
1. Measurement of gain.
2. Plot the frequency response & Determination of Gain Bandwidth Product
Expt No.4 Darlington Amplifier using BJT.
1. Measurement of gain and input resistance. Comparison with calculated values.
2. Plot the frequency response & Determination of Gain Bandwidth Product
Expt No.5 Source follower with Bootstrapped gate resistance
1. Measurement of gain, input resistance and output resistance with and without
Bootstrapping. Comparison with calculated values.
Expt No.6 Differential amplifier using BJT
1. Measurement of CMRR.
Expt No.7 Class A Power Amplifier
1.Observation of output waveform.
2.Measurement of maximum power output.
3.Determination of efficiency.
4.Comparison with calculated values.
Expt No.8 Class B Complementary symmetry power amplifier
1.Observation of the output waveform with crossover Distortion.
2.Modification of the circuit to avoid crossover distortion.
3.Measurement of maximum power output.
4.Determination of efficiency.
5.Comparison with calculated values.
Expt No.9 Power Supply circuit - Half wave rectifier with simple capacitor filter.
33
1. Measurement of DC voltage under load and ripple factor, Comparison with
calculated values.
2. Plot the Load regulation characteristics using Zener diode.
Expt No.10 Power Supply circuit - Full wave rectifier with simple capacitor filter
1. Measurement of DC voltage under load and ripple factor, Comparison with
calculated values.
2. Measurement of load regulation characteristics. Comparison with calculated values.
LIST OF EQUIPMENTS AND COMPONENTS FOR A BATCH OF 30 STUDENTS
(3 per Batch)
S.No Name of the equipments / Components Quantity
Required Remarks
1 Variable DC Power Supply 8 (0-30V)
2 CRO 10 30MHz
4 Multimeter 6 Digital
6 Function Generator 8 1 MHz
7 DC Ammeter 10
8 DC Voltmeter 10
Consumables (Minimum of 25 Nos. each)
9 BC107, BC147,BC 108, BC 148, BC547, BC
548,
SL 100, SK100 or Equivalent transistors.
10 Resistors 1/4 Watt Assorted
11 Capacitors
12 Inductors
13 Diodes, Zener Diodes
14 Bread Boards
15 Transformers 4
No comments:
Post a Comment
Any doubt ??? Just throw it Here...