Trending: Anna University 8th Sem Results April 2014 May/June 2014 Time Table/ Internal Marks Calculate CGPA Online SSLC Results 2014 12th Result 2014

Test Footer 1

Saturday, July 21, 2012

BM3210 ELECTRONICS CIRCUITS - I LABORATORY SYLLABUS | ANNA UNIVERSITY BE MEDICAL ELECTRONICS ENGINEERING 3RD SEMESTER SYLLABUS REGULATION 2008 2011-2012

Latest: TNEA 2014 Engineering Application Status, Counselling Date, Rank List
BM3210 ELECTRONICS CIRCUITS - I LABORATORY SYLLABUS | ANNA UNIVERSITY BE MEDICAL ELECTRONICS ENGINEERING 3RD SEMESTER SYLLABUS REGULATION 2008 2011-2012 BELOW IS THE ANNA UNIVERSITY THIRD SEMESTER BE MEDICAL ELECTRONICS DEPARTMENT SYLLABUS IT IS APPLICABLE FOR ALL STUDENTS ADMITTED IN THE YEAR 2011-2012 (ANNA UNIVERSITY CHENNAI,TRICHY,MADURAI,TIRUNELVELI,COIMBATORE), 2008 REGULATION OF ANNA UNIVERSITY CHENNAI AND STUDENTS ADMITTED IN ANNA UNIVERSITY CHENNAI DURING 2009


BM3210 ELECTRONICS CIRCUITS - I LABORATORY L T P C
0 0 3 2
Expt No.1 Fixed Bias amplifier circuit using BJT
1. Waveforms at input and output without bias.
2. Determination of bias resistance to locate Q-point at center of load
line.
3. Measurement of gain.
4. Plot the frequency response & Determination of Gain Bandwidth
Product
Expt No.2 Design and construct BJT Common Emitter Amplifier using voltage
divider bias
(self-bias) with and without bypassed emitter resistor.
1. Measurement of gain.
2. Plot the frequency response & Determination of Gain Bandwidth
Product
Expt No.3 Design and construct BJT Common Collector Amplifier using voltage
divider bias
(self-bias).
1. Measurement of gain.
2. Plot the frequency response & Determination of Gain Bandwidth
Product
Expt No.4 Darlington Amplifier using BJT.
1. Measurement of gain and input resistance.
2. Comparison with calculated values.
3. Plot the frequency response & Determination of Gain Bandwidth
Product
Expt No.5 Source follower with Bootstrapped gate resistance
1. Measurement of gain, input resistance and output resistance with
and without Bootstrapping.
2. Comparison with calculated values.
Expt No.6 Differential amplifier using BJT
1. Measurement of CMRR.
Expt No.7 Class A Power Amplifier
1. Observation of output waveform.
2. Measurement of maximum power output.
3. Determination of efficiency.
4. Comparison with calculated values.
Expt No.8 Class B Complementary symmetry power amplifier
1. Observation of the output waveform with crossover Distortion.
2. Modification of the circuit to avoid crossover distortion.
3. Measurement of maximum power output.
4. Determination of efficiency.
5. Comparison with calculated values.
31
Expt No.9 Power Supply circuit - Half wave rectifier with simple capacitor filter.
1. Measurement of DC voltage under load and ripple factor,
Comparison with calculated values.
2. Plot the Load regulation characteristics using Zener diode.
Expt No.10 Power Supply circuit - Full wave rectifier with simple capacitor filter
1. Measurement of DC voltage under load and ripple factor,
Comparison with calculated values.
2. Measurement of load regulation characteristics. Comparison with
calculated values.
TOTAL : 45 PERIODS

No comments:

Post a Comment

Any doubt ??? Just throw it Here...